OVMS V3 HUD/OBDII-F cable. One end (DA26-M) connects to the OVMS V3 DIAG (expansion) connector. The other end provides a OBDII female (J1962-F) connector. Cable wiring is as follows:
- J1962-F DA26-M Signal
- 4 8 Chassis/Power GND
- 5 8 Chassis/Power GND
- 6 16 CAN-H (primary CAN)
- 14 6 CAN-L (primary CAN)
- 16 18 +12V Vehicle Power
- Cable includes a 120ohm resistor between DA26 pins 16 and 6.
- This provides for an OBDII expansion port for OVMS V3 and allows devices such as OBDII dongles, Heads-up-Displays (HUDs), etc, to be connected to OVMS using the 'obd2ecu' firmware module.
- 12 cm long
Tested compatible with this HUD.